Window Boards

Window Boards 

Measuring up the window board - using a tape

Measure inside of the window reveal using a tape, find the dimension of the window board lugs by measuring off the back of the window to the inside face of the inner skin of the super structure using the tape.

 

Marking out the window boards - using a pencil, tape and set square

Add the length of the lugs to the length of the reveal and mark the dimension onto the window board using the tape and pencil, mark the length of the lugs back off each end of the window board using the tape and pencil, mark from the back of the window board the dimension that was taken from the back of the window to the face of the inner skin of the super structure using the tape and pencil, square up the mark using the pencil and set square.

 

Cutting of the window board - using a jig saw

Cut along the lines that have been marked out from the previous stage using the jig saw.

 

Fit of the window board - using a spirit level and nail gun

Place the cut window board into the window reveal, level up the window board using the spirit level, place packers where required so the window board is sat solidly on the inner skin of the super structure, fix the window board down using nail gun.